SEARCH:
  
  01952 540 100
Mon - Fri 9PM - 5PM
Wholesale
Categories
Buggies
Clearance
Gadgets
Homeware
Indoor Play
Mini Motos
Outdoor Activities
Pit Bikes 50cc - 160cc
Quad Bikes
Radio Control Boats
Radio Control Planes
Radio Control Tanks
Radio Control Toy Cars
Rc Controller Kits
RC Drones And Helicopters
RC Electric Brushless Pro Cars
RC Electric Pro Cars
RC Nitro Pro Cars
Scooters
Tamiya Self Build RC
Spares &
Accessories
Batteries,Chargers & Adapters
Clothing & Accessories
Mini Moto / Quad Spares
Oil's And Cleaning Products From Silkolene
Pit Bike Spares
RC Boat Spares
RC Car Spare Parts
RC Electrical Spares
RC Helicopter Spares
Wholesale
Drop Shipping
Before Using A Nitro Car

Before Using A Nitro Car

Before using any nitro model it is important that you check the following:

* Receiver Battery
* Range check (Stand a distance away from the model and make sure it is responding to the radio control correctly. Ideally do this with someone else so you can stand as far away as you want to use the model.
* Radio Battery 
* Glow Plug is tight and glow start is fully charged
* Ensure engine flywheel is tight and tighten if needed (IMPORTANT OR THE FLYWHEEL WILL WEAR AWAY) 
* Loctite/tighten any loose nuts, screws or bolts. ie: set screws, engine mount screws, wheel nuts, etc 
* Clutch-bell and Spur Gear mesh (IMPORTANT OR YOU WILL STRIP YOUR GEARS) 
* Pullstart engine screws 
* Nylon ties for exhaust 
* Clean & Re-Oil or replace Foam Air Filter element 
* Ensure all servo & throttle linkage is straight at 90 degrees & in proper alignment when the radio equipment is turned on. Adjust if needed.
* Ensure fuel system is free of obstruction, line pinches, dirt & leaks 
* Clean entire car after every tank - watch for sand, rocks, mud, debris or anything that will hinder proper operation and maintenance.

The above maintenance should be observed ideally after every run.

The main adjustment screw would have been pre-set at the factory and we would have double checked it to make sure it is correct for running the engine in. In 99% of cases this screw will not need touching until after you have run the engine in if you wish to fine tune it. If you do loose the starting position of the screw or want to check it then the top of the screw should be just 1 - 2 mm below the top of the screw casing.

   © Wicked Distribution 2010 Help      About Us      Terms and Conditions      Returns Policy      News Feed      Drop Shipping
About dropshipperscentral.co.uk      Links      Sitemap      Wicked Distribution Mobile Website
   Home   |   Contact